65
Maintaining Your Product
Restoring to initial state
This section describes how to restore the product to the initial state.
There are two ways of restoring the product to the initial state as follows:
• Performing the operation on a PC
• Performing an operation with the product’s control panel
Performing the operation on a PC
1
Check that all jobs are finished.
See “Checking the job processing status” on page 44 in this guide for details on the check procedure.
2
Log in to EPSON Total Disc Net Administrator.
See “Logging in to EPSON Total Disc Net Administrator” in the PP-100N User’s Guide for the login procedure.
3
Click the [Data] tab on the [Maintenance] screen.
• The product should be restored to the initial state by the administrator, and should not be
left unattended until the work is finished.
• Before starting work to restore the product to the initial state, perform a backup (see
“Backing up data” on page 62 in this guide) as necessary. Restoring the product to the
initial state deletes all of the set information, including the user information and system
settings, as well as all job history. The backup file can be restored (see “Restoring data” on
page 64 in this guide) after initialization is finished.
Even if the product is restored to the initial state, the product’s usage status data is not
deleted. See “Checking maintenance information” on page 68 in this guide for details on the
usage status.
To Next Page
Loading...
