25
Preparation
Setting procedure
After installing the stackers, use the procedure below to set the Publish Mode.
1
In the mode selection screen displayed on the LCD, use ▲/▼ to display the Publish Mode
to use, and press the button.
2
When the confirmation message appears, press the button.
The initialization operation begins. Initialization takes two to three minutes.
When initialization is finished, [Please register an administrator] appears on the LCD.
• Never turn the power off during initialization.
• An administrator needs to be registered to use this product. After you finish configuring the
network settings (see page 26 in this guide), be sure to register an administrator. See
“Registering an administrator” on page 31 in this guide for the procedure for registering an
administrator.
• The operation of this product differs depending on the Publish Mode setting. To prevent
the occurrence of an unexpected warning or error, check that the correct Publish Mode has
been set after you set or change the Publish Mode.
After you set the Publish Mode, you can change the language setting for messages displayed
on the LCD of this product from English to Spanish, French, Italian, Dutch, Portuguese,
Japanese, or German. See “Setting the language” on page 42 in this guide if you want to
change the language setting.
To Next Page
Loading...
