Epson C11CA31021NU User Manual

84
Loading discs
This section describes how to load discs in the stacker, and insert the stacker.
1
Fully separate the discs to prevent them from sticking together.
2
Take out the input stacker and load the discs into it.
The stacker to use as the input stacker differs depending on the set Publish Mode. Confirm the input stacker in
the following table.
Load the discs in a stacker. Do not load discs in the drives or printer. Furthermore, do not
load discs between Drive 1 and Drive 2. They may become unable to be taken out.
 Be sufficiently careful not to scratch a disc.
 If a long time elapses after discs are loaded in the stacker, the separated discs may
stick together again. Fan the discs again if a long time has elapsed since they were
loaded.
Do not replenish or remove discs while the stacker is attached to this product. Be sure to
remove the stacker beforehand.
Publish Mode Input Stacker Number of Discs
Standard Mode Stacker 1 Up to approximately 50 discs
External Output Mode
(Different types of discs can be loaded into Stacker 1
and Stacker 2.)
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Batch Mode Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Place the label surface facing upwards.

Epson C11CA31021NU Specifications

General

Brand	Epson
Model	C11CA31021NU
Category	Computer Hardware
Language	English