About Your Printer’s Default Settings
The default settings control many printer functions. While you can often set these functions through
your software or printer driver, you may sometimes need to change a default setting from the printer’s
control panel using the Default Setting mode.
Default Setting mode
The following table is the default settings and the options you can select in the Default Setting mode.
The settings are explained in detail after the table. For instructions on changing the default settings, see
“Changing default settings” on page 97.
Item
Setting / value *
1
Page length for front tractor*
2
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12, 14, 17
Page length for rear tractor*
2
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12, 14, 17
Skip over perforation
Off, On
Auto tear off*
2
Off, On
Auto tear-off wait time*
2
0.5 seconds, 3 seconds
Auto line feed
Off, On
Print direction
Bi-D, Uni-D
Software
ESC/P, IBM PPDS
0 slash
0,
(the zero character with a slash)
I/F (interface) mode
Auto, Parallel, Serial*
3
, USB, Network*
3
Auto I/F (interface) wait time
10 seconds, 30 seconds
Parallel I/F bidirectional mode
Off, On
Packet mode
Auto, Off
FX-890II/FX-890IIN/FX-2190II/FX-2190IIN User’s Guide
Control Panel 92
To Next Page
Loading...
Need help?
General