Epson DS-560 Network Guide

B
Open the input tray.
C
Turn on the product.
D
Hold down the Connect button on the product for at least three seconds until the Status and Error lights on the
product flash alternately.
The product enters standby status for WPS connection for two minutes, and the Status light stays on.
E
On the device you want to connect the product to, press the WPS button or start the WPS function.
Note:
You need to finish this step within approximately two minutes. Otherwise, the standby status for WPS connection is
cancelled.
Check whether or not connection has been established correctly on your computer or device.
DS-560 Network Guide
Using Product via Network
18

Epson DS-560 Specifications

General

Brand	Epson
Model	DS-560
Category	Scanner
Language	English