Epson DS-560 Network Guide

Windows 7/Windows Vista/Windows XP:
Start > All Programs or Programs > EPSON > EPSON Scan > EPSON Scan Settings
Mac OS X:
Select Applications > EPSON Software > EPSON Scan Settings.
B
Click Test.
Checking the Wi-Fi module firmware version
A
Start EpsonNet Config.
Windows 8.1/Windows 8:
Start screen > Apps > EpsonNet > EpsonNet Config
Windows 7/Windows Vista/Windows XP:
Start > All Programs or Programs > EpsonNet > EpsonNet Config VX* > EpsonNet Config
Mac OS X:
Select Applications > Epson Software > EpsonNet > EpsonNet Config VX* > EpsonNet Config.
* Where "X" is the software version.
B
Select your scanner, and then click Configuration.
C
Select Network Interface - Information - Basic.
D
Click Software Information....
Checking the communication using the Ping command
You can use this feature to confirm whether communication is established between the computer and the product.
This method is only available if you have acquired the product’s IP address in advance, such as in the following
situations.
❏ You have set a static IP address for the product and have taken a note of it.
❏ You took a note of the product’s IP address when you setup the network, and it has not been changed by settings on
the access point or the product.
For more details about operating the computer, refer to “Ping command” on page 24.
Ping command
In the TCP/IP network environment, confirm the IP addresses set on the computer and product, then check whether
communication is established between the computer and product.
DS-560 Network Guide
Troubleshooting
24

Epson DS-560 Specifications

General

Brand	Epson
Model	DS-560
Category	Scanner
Language	English