Epson DX5 X 2 - Software Calibration; Nozzle Checking Procedure; Vertical Calibration: Initial Setup

10
Chapter
Chapter
Chapter
Chapter 7.
7.
7.
7.
Software
Software
Software
Software Calibration
Calibration
Calibration
Calibration
1. Nozzle checking: P rint the nozzle checking to check the condition of the printhead.
Make
Make
Make
Make sure
sure
sure
sure to
to
to
to turn
turn
turn
turn off
off
off
off the
the
the
the Eclosion
Eclosion
Eclosion
Eclosion (Feather)
(Feather)
(Feather)
(Feather) function
function
function
function before
before
before
before doing
doing
doing
doing the
the
the
the alignment.
alignment.
alignment.
alignment.
Base on the Head Status diagram to adjust vertical position between two printhead. The setting is at
“ Option ” -> “ Calibration ” -> “ The distance between the two heads ”
Case 1: Have to increase the value between the two heads:
Case 2 ： Have to decrease the value between the two heads:
2
nd
printhead
status locate on
the right side of
1
st
printhead
1
st
printhead
status
2
nd
printhead
status ：
2
nd
printhead
status locate on
the left side of
1
st
printhead
1
st
printhead
status ：
2
nd
printhead
status ：