20
9.4
9.4
9.4
9.4 Daily
Daily
Daily
Daily Maintenance
Maintenance
Maintenance
Maintenance
1. Print the nozzle checking before turn off the machine to make sure the printhead is in normal condition
2. Turn off the software, carriage go back to Home position automatically . Turn off the machine, the carriage stay
at the Home position.
3. Use sponge stick with appointed Flush to clean the cap and the wiper everyday before turning on the machine .
1
）
9.5
9.5
9.5
9.5 Short
Short
Short
Short term
term
term
term shut
shut
shut
shut down
down
down
down (3~7
(3~7
(3~7
(3~7 days)
days)
days)
days)
1. Disconnect the tube connector on top of the damper . Use Standard clean mode to empty the ink in the damper.
(2 times)
2. Use a extend tube to connect the dampe r to the appointed Flush.
Choose Depth clean mode to clean the damper and the printhead at the same time.(2 times)
3. Take out the extend tube from the Flush, and keep it out in the air. Choose Depth clean mode to empty the
Flush inside the damper and the printhead. Use the tube cove r to seal the ink incoming tube, keep the cartridge
back to Home position and make sure the capping pad is perfectly capping the printhead.
9.6
9.6
9.6
9.6 Long
Long
Long
Long term
term
term
term shut
shut
shut
shut down
down
down
down (More
(More
(More
(More than
than
than
than a
a
a
a week)
week)
week)
week)
1. Print status before turn off the machine, make sure printhead in good condition..
2. Disconnect the tube connector on top of dampers, let the ink flow back to the cartridge.
To Next Page
Loading...
Need help?
General
