Indicators Cause Remedy or Status
Power sup
ply
Status Lamp Tempera
ture
Off Blue - Flash-
ing
Orange - Lit Off
Lamp Error
Lamp Failure
Check the following two points.
• Take out the lamp and check if it is cracked.
s "Replacing the Lamp" p.148
• Clean the air filter.
s "Cleaning the Air Filter" p.146
If the lamp is not cracked: Reinstall the lamp and plug in the power cord.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
If the lamp is cracked: Contact your local dealer or the nearest address provided in the Epson
Projector Contact List. (Images cannot be projected until the lamp is replaced.)
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.106
Lamp Cover Open Check that the lamp and the lamp cover are securely installed.
The lamp does not turn on if the lamp and the lamp cover are not installed correctly.
s "Replacing the Lamp" p.148
Off Blue - Flash-
ing
Orange -
Flashing
Orange -
Flashing
Auto Iris Error Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Off Blue - Flash-
ing
Orange - Lit Orange - Lit
Power Err.
Blue - Flash-
ing
State de-
pendant in-
dication
State de-
pendant in-
dication
Orange -
Flashing
High Temp Warn-
ing
(This is not an abnormality. However, if the temperature rises too high again, projection stops
automatically.)
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned
against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.146, "Replacing the Air Filter" p.151
Problem Solving
132
To Next Page
Loading...
Need help?
General
