EH-TW3500/4500/5500 Appendix CONFIDENTIAL
SEIKO EPSON 105 Revision A
2nd page
The error log of the projector is displayed.
• The last 5 error logs are displayed (the latest on top). None is displayed if there’s no
error.
• In the case of the display in the previous page, the latest error is “Internal Overheat”.
When error occurred, Total Operation Time was 9 hours 46 minutes 57 seconds, Lamp
Operation Time was 5 hours 36 minutes 27 seconds, the time after the lamp turned ON
was 0 hours 2 minutes 23 seconds, the projector’s status was “Lamp ON”.
• The 2nd latest error is “Fan Error”. When error occurred, Total Operation Time was 8
hours 35 seconds 34 minutes, Lamp Operation Time was 5 hours 34 minutes 4 seconds,
the time after the lamp turned ON was 0 hours 0 minutes 1 second, the projector’s status
was “Warming up”.
No. Description
1 Error log items. see Table 4-1 “Error log items”
2 Last 5 error logs are displayed. #2 (top) is the latest.
3 Error count
4 Control Data 1
5 Control Data 2
CD TOT (h
:m:s) LOT (h:m:s) POT (h:m:s) ST
:m:s) LOT (h:m:s) POT (h:m:s) ST
Error : TH 00009 4657 00005 3627 00000 0223 01
Error : TH 00009 4657 00005 3627 00000 0223 01
Log : FN 00008 3534 00005 3404 00000 0001 02
Log : FN 00008 3534 00005 3404 00000 0001 02
: LC 00008 4246 00005 0516 00000 1441 01
: LC 00008 4246 00005 0516 00000 1441 01
: LF 00007 3451 00004 4221 00000 0000 02
: LF 00007 3451 00004 4221 00000 0000 02
: LF 00007 3451 00004 4221 00000 0000 02
: LF 00007 3451 00004 4221 00000 0000 02
Error : TH01 FN01 SE00 LE00 LF02 RA00 RO00 II00
Error : TH01 FN01 SE00 LE00 LF02 RA00 RO00 II00
Count : ID00 LC01 EC00 CF00 AI00 RS00 RP00 DU00
Count : ID00 LC01 EC00 CF00 AI00 RS00 RP00 DU00
: WL00 WS00 PB00 IV00
Control : 1C1D 73717497
Table 4-1. Error log items
Item Contents Representation
Error Log
CD Error Code Two alphabets
TOT Total Operation Time
h: 5-digit number (00000-
65535)
Over 65535: “65535” (Not
cleared to “0.”)
m: 2-digit number (00-59)
s: 2-digit number (00-59)
LOT Lamp Operation Time
POT Time after Lamp is ON
ST PJ (Projector)’s status
Acquired data of PWR? of the
ESC/VP21 command
To Next Page
Loading...
Need help?
General
