Configuration Menu
53
Function Menu/Settings Explanation
HDMI Link
Device Connections - Displays a list of devices connected to the
HDMI ports.
HDMI Link On, Off Enables or disables the HDMI Link function.
Audio Out Device Projector, AV Sys-
tem
Selects which device outputs audio.
s p.47
Power On Link Off, Bidirectional,
Device -> PJ, PJ ->
Device
Sets the link function when the power is turned
on.
•
To turn on the projector when you operate the
connected device, select Bidirectional or De-
vice -> PJ.
•
To turn on the connected device when you turn
on the projector, select Bidirectional or PJ ->
Device.
Power Off Link On, Off Sets whether or not to power off connected de-
vices when the projector is turned off.
Bluetooth
Search Bluetooth
Device
- Searches for available Bluetooth devices and dis-
plays them as a list.
Bluetooth Audio On, Off Enables or disables audio output from Bluetooth
audio devices.
Setup cannot be performed in the following ca-
ses.
•
When Audio Out Device from the HDMI Link
menu is set to AV System
Connected Device - Displays information on the connected Blue-
tooth audio device.
Lock Setting
Child Lock On, Off This locks the standby button on the projector's
control panel to prevent children from turning
on the projector by accident. You can turn on the
power when locked by holding down the stand-
by button for approximately three seconds. You
can still turn off the device using the standby
button or perform operations with the remote
control as usual.
If changed, this setting is enabled after you pow-
er off the projector and the cool-down process is
complete.
Note that even if Child Lock is set to On, the pro-
jector still turns on when the power cord is con-
nected if Direct Power On is set to On.
Control Panel Lock Full Lock, Partial
Lock, Off
Full Lock: Disables all of the projector's buttons.
Partial Lock: Disables all of the projector's but-
tons except for the standby button.
is displayed on the screen if buttons are
pressed while the projector is locked. To unlock,
press and hold the standby button on the control
panel for at least 7 seconds.
If changed, this setting is enabled once you close
the Configuration menu.
To Next Page
Loading...
Need help?
General
