Maintenance
70
a
Press the standby button on the
remote control or the control panel to
turn off the power, and then
disconnect the power cord.
b
Open the air filter cover.
c
Remove the air filter.
Grip the air filter cover tab and pull it
straight up.
d
Hold the air filter with the surface
facing down and tap it 4 or 5 times to
remove the dust.
Tap the air filter on its side to remove the
dust.
Attention
If the air filter is hit too hard, it may
become unusable due to deformities
and cracks.
e
Remove any dust remaining on the air
filter by using a vacuum cleaner from
the front side.
f
Install the air filter.
Slide in the air filter until it clicks into place.
g
Close the air filter cover.
Cleaning the main unit
Before cleaning, make sure you unplug the power cord from the outlet.
Clean the projector's surface by wiping it gently with a soft cloth.
To Next Page
Loading...
Need help?
General
