Epson EH-TW5910 User Manual

Basic Operations
23
If the Target Image is not Projected
If the image is not projected, you can change the source using one of the following methods.
Remote control Control panel
Press the button for the target port.
Press the
button and select the target port.
Press the
button to confirm the selection.
EH-TW6100W EH-TW6100/EH-TW5950
c
•
For video equipment, start playback first and then change the source.
•
If the color looks unnatural when changing to a Video or Component source, check that the port you
have connected to is the same as the Input Signal.
s Extended - Input Signal - Video Signal/
Component p.73
Turning Off
a
Turn off the connected equipment.
b
Press the button on the remote
control or the projector's control
panel.
Remote control Control panel
A confirmation message is displayed.
c
Press the button again.
c
When Standby Confirmation is
set to Off, you can turn off the
projector by pressing the
button on the remote control
once.
s Extended - Display -
Standby Confirmation p.73
d
Wait until cool-down is complete.
The operation indicator on the projector's
control panel stops flashing.
e
Disconnect the power cable.
c
If the power cable is connected,
some electricity is consumed even
if no operations are made.

Epson EH-TW5910 Specifications

Image

color light output	2, 100 lumen
white light output	2, 100 lumen
resolution	1920 x 1080
contrast ratio	20, 000:1

Optical

projection ratio	1.32 - 2.15:1
projection size	30 inches - 300 inches
projection distance wide	0.9 m - 8.9 m
projection distance tele	1.4 m - 14.5 m

Power

energy use	358 W
economy energy use	274 W
standby energy use	0.35 W

Connectivity

interfaces	RS-232C, VGA in, HDMI 1.4 (2x), Composite in, USB 2.0 Type A, USB 2.0 Type B, Component in
loudspeaker	20 W
stereo	Stereo

Weight and Dimensions

product dimensions	420 x 365 x 137 mm
product weight	6 kg
noise level economy	24 dB (A)