Epson EMP-70 - Page 31

29
Projection
When preparations are complete, you are ready for projection.
1.
To use the remote control, turn the remote
control R/C On Off switch to "On".
2.
Press the Power button to switch power on.
The operation display indicator begins to
flash green, and projection begins.
After approximately 30 seconds, the
operation display indicator changes from
flashing green to steady green.
"No-Signal" is displayed.
Depending on your settings,
there may be no display.
(See page 51)
The operation display indicator
lights green.
EMP‑7050e.book29ページ２００１年１月９日 火曜日 午前９時２５分