C
To end the registration operation, click in the top-right
corner of the window or click "Cancel".
The icon(s) of the projector(s) you registered will be displayed in
Grouping view or Detail list view.
Refer to
s "Monitoring window layout" p.19 for details on
using the Grouping view and Detail list view.
Setting the range of addresses to do an
automatic search and registration
q
Projectors that are using a serial W TCP/IP conversion adapter
cannot be detected.
Procedures for automatic search
Procedure
A
Right-click in Grouping view and select "New" - "Projector
(automatic search)".
The Create new projector (automatic registration) window will be
displayed.
If Detail list view is displayed, select New - Projector (automatic
search) from the Edit menu.
B
Select the "Specify an address range and search" check box
and then enter "Start address" and "End address" in the range.
C
Click "Search".
Automatic searching will be carried out, and the names of the
projectors that have been detected will be displayed.
Registering and deleting projectors for monitoring
12
To Next Page
Loading...
