Epson Endeavor - Page 10

Changing the Processor Speed
..................
l-24
Preparing the Hard Disk for Moving
...............
l-26
Using AUTOEXEC.BAT and Other Batch Files
.........
l-27
Chapter 2
Installing and Removing Options
How to Use This Chapter
.....................
2-2
Locating the Internal Components
.............
2-3
Removing the Cover
........................
2-4
Changing the Jumper Settings
...................
2-6
Setting the Jumpers
......................
2-9
Memory Modules (SIMMs)
....................
2-11
Inserting SIMMs
........................
2-13
Removing SWIMS
.......................
2-15
Installing an Option Card
.....................
2-16
Removing an Option Card
..................... 2-20
Removing the Option Card Connector Board
..........
2-21
Replacing the Option Card Connector Board
..........
2-22
Installing a New Processor Chip
.................
2-23
Increasing the Video Memory
...................
2-24
Installing the Memory Chips
.................
2-24
Using the Alternate VGA Interface
................
2-26
Using a Display Adapter Card
..................
2-28
Replacing the Cover
........................
2-29
Post-installation Procedures
....................
2-30
Chapter 3
Installing and Removing Drives
How to Use This Chapter
.....................
3-3
Setting the Hard Disk Drive Jumpers
...............
3-4
Where to Go Next
.......................
3-4
Installing a Hard Disk in the Vertical Bay
............
3-5
Removing the Mounting Frames
..............
3-6
Installing the Hard Disk
...................
3-8
Connecting the Cables
....................
3-12
Removing a Hard Disk From the Vertical Bay
.......... 3-15
viii