Epson Endeavor - Page 11

Installing a Drive in a Horizontal Bay
...............
3-17
Attaching Mounting Frames to a Hard Disk
........ 3-19
Installing the Drive
.......................
3-20
Connecting the Cables
.....................
3-24
Removing a Drive From a Horizontal Bay
............
3-29
Connecting the Hard Disk Drive Ribbon Cable to the
System Board
...........................
3-33
Post-installation Procedures
....................
3-36
Chapter 4
Running System Diagnostics
Starting the Program
........................
4-2
Deleting Tests
.......................... 4-3
Adding Tests
..........................
4-4
Running Tests
............................
4-5
Resuming From an Error
...................
4-6
System Diagnostic Tests
......................
4-7
Error Messages
............................
4-8
Chapter 5
Formatting a Hard Disk
Starting the Program
........................
5-2
Formatting a New Disk
....................
5-3
Reformatting a Used Disk
..................
5-3
Selecting an Option
......................
5-3
Selecting a Drive
........................
5-4
Option 1, Format
...........................
5-4
Modifying the Defective Track Table
............
5-6
Formatting the Disk
......................
5-8
Option 2, Destructive Surface Analysis
..............
5-9
Option 3, Non-destructive Surface Analysis
...........
5-10
Exiting the Program
.........................
5-11
ix