Epson ET-2870 Series - Fax Send Settings

Related Information
& “Sending Dierent Size Documents Using ADF (ADF Continuous Scan)” on page 104
Fax Send Settings
Select the menus on the control panel as described below:
Fax > Menu > Fax Send Settings
Direct Send:
Sends a monochrome fax while scanning the originals. Since scanned originals are not stored
temporarily in the printer's memory even when sending a large volume of pages, you can avoid
printer errors due to a lack of memory. Note that sending using this feature takes longer than not
using this feature. See the related information below on this topic.
You cannot use this feature when sending a fax to multiple recipients.
Send Fax Later:
Sends a fax at a time you specied. Only a monochrome fax is available when using this option. See
the related information below on this topic.
Add Sender Info:
Select the position where you want to include the header information (sender name and fax number)
in the outgoing fax, or not to include the information.
O O: Sends a fax with no header information.
O Outside of Image: Sends a fax with header information in the top white margin of the fax. is
keeps the header from overlapping with the scanned image, however, the fax received by the
recipient may be printed across two sheets depending on the size of the originals.
O Inside of Image: Sends a fax with header information approximately 7 mm lower than the top of
the scanned image.
e
header may overlap with the image, however, the fax received by the
recipient will not be split into two documents.
Add Sender Info:
Fax Header
Select the header for the recipient. To use this feature, you should register multiple headers in
advance.
Additional Header Info:
Select the information you want to add. You can select one from Your Phone Number and
Destination List.
Transmission Report:
Prints a transmission report
aer
you send the fax.
Print on Error prints a report only when an error occurs.
When Attach Fax image to report has been set in Settings > Fax Settings > Report Settings, faxes
with errors are also printed with the report.
Faxing > Menu Options for Faxing > Fax Send Settings
109