Epson ET-2870 Series - An Error Code is Displayed on the LCD Screen

Cannot Make Calls on the Connected Telephone
The phone cable is not connected correctly.
Solutions
Connect the telephone to the EXT. port on the printer, and pick up the receiver. If you cannot hear a dial
tone through the receiver, connect the phone cable correctly.
Answering Machine Cannot Answer Voice Calls
The printer's Rings to Answer setting is set to less than the number of rings for your
answering machine.
Solutions
Select Slow(9,600bps) in Settings > Fax Settings > Basic Settings > Rings to Answer, and then set to a
number higher than the number of rings for your answering machine.
A Lot of Junk Faxes Have Been Received
The printer's feature to block junk faxes has not been set up.
Solutions
Make Rejection Fax settings in Settings > Fax Settings > Basic Settings.
“Making Settings for Blocking Junk Faxes” on page 95
A Message Prompting You to Reset the Ink Level is Displayed Even After
Relling
the Ink
Ink level was not reset.
Solutions
Aer relling
the ink, follow the on-screen instructions to reset the ink level.
The Ink Level Display does not Change Even After Relling the Ink
Ink level was not reset.
Solutions
Aer relling the ink, follow the on-screen instructions to reset the ink level.
An Error Code is Displayed on the LCD Screen
A code is displayed on the LCD screen if there is an error or information that requires your attention. If a code is
displayed, follow the solutions below to solve the problem.
Solving Problems > An Error Code is Displayed on the LCD Screen
188