Epson ET-2870 Series - Page 272

Communication Mode Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps
Full duplex, 100Mbps Half duplex
Connector RJ-45
*1 Use a category 5e or higher STP (Shielded twisted pair) cable to prevent risk of radio interference.
*2 The connected device should comply with IEEE802.3az standards.
*3 IEEE802.3az is disabled by default. See "Related Information" to enable this setting.
Related Information
& “Enabling Energy Ecient Ethernet” on page 227
Network Functions and IPv4/IPv6
Functions Supported Remarks
Network Printing EpsonNet Print (Windows) IPv4
✓
-
Standard TCP/IP (Windows) IPv4, IPv6
✓
-
WSD Printing (Windows) IPv4, IPv6
✓
Windows Vista or
later
Bonjour Printing (Mac OS) IPv4, IPv6
✓
-
IPP Printing (Windows, Mac
OS)
IPv4, IPv6
✓
-
PictBridge Printing (Wi-Fi) IPv4 - Digital camera
Epson Connect (Email Print,
Remote Print)
IPv4
✓
-
AirPrint (iOS, Mac OS) IPv4, IPv6
✓
iOS 5 or later, Mac
OS X v10.7 or later
Network Scanning Epson Scan 2 IPv4, IPv6
✓
-
Epson ScanSmart IPv4
✓
Windows 7 or later,
Mac OS X El
Capitan or later
Event Manager IPv4
✓
Windows XP, Vista,
Mac OS X v10.6 to
Yosem ite
Epson Connect (Scan to
Cloud)
IPv4 - -
AirPrint (Scan) IPv4, IPv6
✓
OS X Mavericks or
later
Product Information > Product Specications > Network Specications
272