3.
To switch from cut
sheet
feeder operation to continuous paper, pull
the paper release lever all the way forward to the continuous paper
position. You do not need to change the DIP switch setting.
4. Raise the paper path guide on the cut sheet feeder until it clicks open, as
shown below. This guide directs the flow of continuous paper out of the
front
of the printer.
5. With the paper release lever foward,
the
control panel functions
normally. This allows you to use micro-adjustment to adjust the
loading position of your paper.
6.
To switch back to
the
cut sheet feeder, push
the LOAD/EJECT
button
until the continuous paper feeds backward out of
the
paper path and
into a standby position. Push
the
paper release lever back to put the
printer into the sheet feeder mode, and then close the paper path
guide.
Using Printer Options
7-13
To Next Page
Loading...
