Plugging in the printer
Follow these steps to plug in the printer:
1. Be sure the printer is turned off.
2.
Plug the power cable into a properly grounded electrical outlet.
WARNING: Whenever you turn off the power, wait at least
five seconds before turning it back on. Rapid switching on
and off can damage the printer.
Loading a sheet of paper
Next, you need to load a sheet of paper
that
is letter size (if you have an
FX-850) or 14 inches wide (if you have an FX-1050).
WARNING: Before turning on the printer, be absolutely sure
you have removed all protective materials. Turning on the
printer while the print head cannot move may seriously
damage the print mechanism.
1.
Turn on the printer. The green
POWER
and red
PAPER OUT
lights come
on.
Setting Up the Printer
1-13
To Next Page
Loading...
