4.
5.
6.
Tilt the tractor unit toward you until the front latches click in place
over the front mounting pins of the printer.
Now load paper as described in the section on loading continuous
paper in Chapter 2. However, position the left sprocket unit about
l/4
of an inch from the left before locking it in place.
After the paper is loaded in the push tractor, make sure the printer is
off line and then press the
FORM FEED
button. This advances the
paper one page so you can fit
the
paper onto the pull tractor.
Caution:
Never use the platen knob to feed the paper while the printer
is turned on. If you need to adjust the loading position, use the micro-
adjustment function described in Chapter 2.
7.
Open the sprocket covers, and release the sprocket lock levers.
Using
Printer
Options
7-17
To Next Page
Loading...
