Epson FX-1050 - Page 166

ESC W
Turn Double-Wide Mode On/Off
Format:
ASCII code:
ESC W n
Decimal : 27 87 n
Hexadecimal: 1B 57 n
Comments:
The following values can be used for n:
1: Mode is turned ON.
(The ASCII codes 0 and 1 or the ASCII
0: Mode is turned OFF.
characters “0” and “1” can be used.)
Double-wide mode doubles the width of all characters. This command
is available in both draft and NLQ.
ESC w
Turn Double-High Mode On/Off
Format:
ASCII code: ESC
n
Decimal: 27
l19 n
Hexadecimal: 1B 77 n
Comments:
The following values can be used for n:
1: Mode is turned ON.
(The ASCII codes 0 and 1 or the ASCII
0: Mode is turned OFF.
characters “0” and “1” can be used.)
Double-hi mode doubles the height of all characters. Superscript,
subscript, and condensed modes are not valid in the double-high
mode. This command is available in both draft and NLQ.
8-28
Command Summary