Running the program
When you run this second program, it prints six characters, then re-
defines some or all of them and prints them again, as in the example
below.
When printed by your own program, these two lines provide you with a
key to the characters your FX can now print. When you press the key for
one of the characters in the top row, the printer prints the corresponding
character in the bottom row. In the example above, if you type < your
FX prints
(although your screen continues to show the character <).
If you have designed a few characters and want to use them with your
word processing program, for example, just run the second definition
program before you start using your word processing program. Then use
the two-line printout as your guide to tell you which keys to press for
your new characters.
4-26
Using Software and Graphics
To Next Page
Loading...
