3.
Move the left edge guide until it locks in place next to the
guide mark. Then adjust the right edge guide to match the
width of your paper.
Caution:
Fun
the self test using paper at least
220
mm (8.2
inches)
wide
fortheLQ-57O+or36Omm(Z4iruhs)rctide~
tk
LQ-2070+;
otkrwGe,
tk
print
kud
prints directly on
tk
plilten.
4.
Insert a sheet of paper between the edge guides until it meek
resistance. After a few seconds, the printer loads the paper
to the loading position andbegins printing the self test.
Setting
Up the
Printer
1-11
To Next Page
Loading...
