11. Turn on the printer. When the printer receives data, it
automatically loads the paper before printing.
Note:
Always close the printer cover before printing. The printer stops
printing when the cover is open.
You can also advance the paper to the loading position by
pressing the
Load/Eject
button.
Advance the paper behind the printer guide as shown below.
Make sure the paper path guide rests against the paper guide.
Caution:
Do not use the knob on the right side of the printer except to clear
paper jams when the printer is off Otherwise, you may damage
the printer or cause it to lose the top-of-form position.
Loading the rear push tractor
1.
Make sure the printer is turned off.
2.
Remove the printer cover and paper guide.
Paper Handling
2-15
To Next Page
Loading...
