Pitch (three lights, green)
The pitch selection status is displayed by three pitch lights:
10 cpi
12
cpi
15
cpi
17 cpi
20
cpi
PS (Proportional spacing)
= On,
n
= Off
Note:
All
of
the lights above me on when a
fatal
error occurs.
Buttons
Operate
Press this button to turn the printer on or off.
Pause
Press this button to temporarily stop printing and to resume
printing. Holding it down for at least 3 seconds when the printer
is in the standby mode enables the micro adjust function. Pressing
it again disables this function. See “Micro Adjust” later in this
chapter for details.
Load/Eject
Press this button to load single-sheet or continuous paper to the
loading position. However, the printer normally loads paper
automatically. If single-sheet paper is already in the loading
position, use this button to eject the sheet. If continuous paper is
in the loading or tear-off position, press this button to feed it
backward to the standby position.
3-4
Using the Printer
To Next Page
Loading...
