Envelopes
You can load envelopes only from the top paper slot, following
the guidelines below:
Always set the paper thickness lever to position 2 to 6 to
match the thickness of the envelope.
Always feed an envelope by pushing the wide edge into
the printer until it meets resistance.
Caution:
Use envelopes only under normal operating conditions.
Printing on the edge
of
an envelope can damage the print
head. Make sure the printing stays entirely within the
printable area
of
the envelopes. See the Appendix
for
details.
Postcards
You can load postcards from the front and top paper slots. Load
cards only under normal operating conditions. Set the Card mode
using the Tear Off/Bin button. See the Tear Off/Bin light and
button descriptions in Chapter 3 for more information.
Note:
When the length
of
the card is less than 14.8 cm (5.8 inches), use
the top paper slot. See the Appendix
for
details.
Use postcards only under normal operating conditions.
Roll paper
Load roll paper from the top paper slot. See “Roll paper holder” in
Chapter 4 for more information.
Paper Handling 2-29
To Next Page
Loading...
