Item
Settings
Skip-over-perforation
On, Off
Auto tear off
On, Off
Auto line feed
On. Off
Auto CR *2
On, Off
AGM *2
On, Off
0 slash
On, Off
Buzzer
On, Off
Roll paper
On, Off
* 1 One of the fonts selected in the Default Setting mode corresponds to
Other on the control panel. The following fonts are not selected in the
Default Setting mode: Draft, Roman, Sans Serif, Courier, Prestige, and
Script.
* 2 These settings are effective when IBM2391 plus emulation is selected.
Default setting item functions
This section describes each of the default setting item functions
Character table
Your printer has 11 standard character tables as well as tables for
20 other countries. See the Appendix for character samples.
international character set for Italic table
You can change 8 characters in the Italic character table to suit
your printing needs. Since these characters are often used in other
languages, they are named after countries and are referred to as
international character sets. See the Appendix for character
samples.
Using the Printer
3-9
To Next Page
Loading...
