4.
Press the
Load/Eject[ ]
button to move the loading position
down on the page, or press the
LF/FF[ ] button
to move the
loading position up on the page.
For continuous paper, mark a point 6.5 mm above the perforation
and position the paper as shown. This gives you an 8.5 mm
margin.
Note:
The printer has a minimum and maximum loading position.
If
you try to advance the loading position beyond these limits, the
printer beeps and the paper stops moving.
When the paper reaches the factory-set loading position, the
printer beeps and paper feeding pauses briefly. Use the factory
setting as a reference point when adjusting the loading position.
3-14
Using the Printer
To Next Page
Loading...
