2-10
Using the Printer
❏ If you use single sheets without an optional cut-sheet feeder, you
need to feed a new sheet of paper each time the printer ejects a printed
sheet.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. While holding down the Tear Off (Font) button, turn on the
printer. The printer enters the Default Setting mode and prints
the language selection instructions (one page).
3. Follow the instructions to select the language you want for
the instruction pages.
4. Load the next sheet of paper, if necessary. The printer prints
the current settings list (one page).
5. Press down the Tear Off (Font) button. The printer prints the
Default Setting mode instructions (three or four pages) in the
language you selected. The printed instructions list the
default settings you can change, describe how to change them,
and show you how the control panel lights help you make
settings.
6. Follow these instructions to change the default settings using
the buttons on the printer’s control panel.
Note:
The arrows on the instruction sheets indicate the printer’s current
settings.
To Next Page
Loading...
