Using the Printer
2-9
2
A.G.M. (Alternate Graphic Mode)
This setting is available only in the IBM 2390 Plus emulation
mode. When A.G.M. is on, the printer can use some advanced
graphics commands like those available in the ESC/P2 mode.
Manual feed wait time
This sets the amount of wait time between the time paper is
inserted into the paper guide and when it is fed. If the paper feeds
before you can adjust its position to your satisfaction, you can
increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs. (See “Using the Error
Indicators” on page 4-2 for more information on printer errors.)
If you do not want the printer to beep when an error occurs, turn
this setting off.
Roll paper
When you turn on this mode, the printer recognizes that single
sheets are not loaded in the printer, so it does not try to eject the
paper and advance it forward to the next page when you press
the LF/FF button.
Changing default settings
Follow these steps to enter the Default Setting mode and change
the printer’s default settings:
Note:
❏ To print the language selection instructions and the Default Setting
mode instructions, you need five or six sheets of A4 or Letter size
single-sheet paper, or five or six pages of continuous paper that is at
least 279 mm (11 inches) long and 210 mm (8.27 inches) wide.
To Next Page
Loading...
