2-30
Using the Printer
Adjusting the paper-thickness lever
Before printing on special paper, you need to change the paper
thickness setting.
Follow these steps to adjust the paper thickness setting:
1. Turn the printer off and open the printer cover. The paper-
thickness lever is on the left side of the printer. The numbers
next to the lever indicate the thickness setting.
2. Use the table below to select the appropriate paper thickness.
3. Close the printer cover.
Paper type Lever position
Standard paper (single-sheet or continuous) 0 or 1
Multipart forms (single-sheet or continuous)
2-sheet
3-sheet
4-sheet
1
2
3
Labels 2
Envelopes 3 to 5
To Next Page
Loading...
