Course and Rudder Angle Printer
2 Installation
10000001193 6 Edition: 001
Fig. 3: Course and Rudder Angle Printer, Interface
6. Reattach the printer to the mounting plate and install the 2 screws on the bottom of the
mounting plate.
7. Install the mounting hooks with the 4 screws.
Note
Ensure that the power switch is set to off.
8. Reattach the power cable (104-034.HP012 / U10) to power connector on the printer.
9. Connect the power cable to a 220 / 240 V AC power outlet and switch on the outlet
power.
2.2 Configure the Printer
Procedure
1. Follow the instructions of the EPSON User Guide, see CD LQ-350 Software Disc.
To Next Page
Loading...
