4. Hold the cut-sheet feeder in both hands and press on the latch
levers. Fit the notches in the cut-sheet feeder over the
mounting posts on the printer. Releasing the latch levers locks
the cut-sheet feeder in place.
5. Slide the left paper guide so it is aligned with the triangle mark.
Next, slide the right paper guide to roughly match the width
of your paper. Slide the paper support midway between the
paper guides.
BB2-16
BB2-17
R
Blueberry REV.F
A5 size Chapter 2
95/05/25
Using the Printer
2-25
To Next Page
