Cleaning and Transporting the Product
If your product gets dirty or you need to move it some distance, follow the instructions in these sections.
Cleaning the Product
Transporting Your Product
Cleaning the Product
To keep your product working at its best, you should clean it several times a year.
Close the output tray and paper support when you are not using the product to protect it from dust.
Caution: Do not use a hard brush, benzene, alcohol, or paint thinner to clean the product or you may
damage it. Do not place anything on top of the cover or use the cover as a writing surface, or it could get
permanently scratched. Do not use oil or other lubricants inside the product or let water get inside.
1. Turn off the product.
2. Unplug the power cable.
3. Disconnect any connected cables.
4. Remove all the paper.
5. Clean the outer case with a soft, dry cloth. Do not use any liquid or chemical cleansers.
Parent topic: Cleaning and Transporting the Product
Transporting Your Product
If you need to ship your product or transport it some distance, prepare it for transportation as described
here.
Caution: During transportation and storage, follow these guidelines:
• Avoid tilting the product, placing it vertically, or turning it upside down; otherwise ink may leak.
• When storing or transporting the ink bottle after removing its seal, do not tilt the bottle and do not
subject it to impacts or temperature changes. Otherwise, ink may leak even if the cap on the ink bottle
is tightened securely. Be sure to keep the ink bottle upright when tightening the cap, and take
measures to prevent ink from leaking when transporting the ink bottle.
1. Turn off the product.
67
To Next Page
Loading...
Need help?
General
