60
Installing the Transparency Unit
Follow the steps below to install the transparency unit on the scanner.
1. Make sure the scanner is turned off.
2. Remove the document cover from the scanner by opening it to an upright
position and lifting it straight up.
3. Make sure the document table glass is clean and
dust free.
4. Place the transparency unit on the document
table glass so that the hinges face the rear of the
scanner and it fits on the document table glass.
5. Connect the transparency unit connector
(arrow faces up) to the scanners option
interface.
6. Turn on the transparency unit.
7. Turn on the scanner.
For information on loading transparencies and
selecting driver settings, see the next section,
Loading Transparencies.
on/off switch
To Next Page
Loading...
