Chapter 5 Control Panel 94
Changing default settings
The following table shows the basic function of each button in the
default setting mode.
Follow these steps to enter the default-setting mode and change
the printer’s default settings:
Note:
❏ Prepare an A4 size sheet of paper before entering the default setting
mode.
❏ You need to load a new sheet of paper each time the printer ejects a
printed sheet from the front slot.
❏ Always close the printer cover before printing. The printer does not
print when the printer cover is open.
1. Turn off the printer.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. Turn on the printer while holding the F1/Eject and F2 buttons
on the control panel.
Button Basic function
F1/EjectSelects thenext menu parameter.
Offline Selects the previousmenu parameter.
F2 Changesthe value in the selected menu.
To Next Page
Loading...
