Displaying and Adjusting the Image 15
Ideally, you should place the projector directly in front of the center of
the screen, facing it toward the screen squarely. The base of the lens
should be at about the level of the bottom of the screen.
If you place the projector below screen level, you’ll have to tilt it up by
extending the front adjustable foot. This causes the image to become
“keystone” shaped, but you can correct the distortion by pressing the
buttons on the projector. See page 23 for detailed information about
correcting the image shape.
For instructions on installing the projector in a permanent location,
such as a theater or conference room, see page 89.
Turning the Projector On and Off
Make sure your projector and any computer or video equipment are
connected as described on page 39. Turn on your connected
equipment before starting the projector so it can automatically detect
and display the image source. If you turn on the projector first, or
have multiple pieces of connected equipment, you may have to select
the image source manually (see page 18).
note
After positioning the
projector, you may want to
connect a Kensington
MicroSaver
®
anti-theft
device to the lock port on the
projector. You can purchase
this from Epson; see
page 12.
Screen
Projector
To Next Page
Loading...
Need help?
General