Solving Problems 79
Viewing Lamp Usage and Other Information
Use the Info menu to view information about the display settings of
your computer and the number of hours the lamp has been used.
Press the
Menu button and highlight the Info menu.
You see the lamp usage hours and various input signal settings on the
right.
The life span of the lamp is about 3000 hours if the
Brightness
Control
setting in the Setting menu is set to High (default), and
4000 hours if the
Brightness Control setting is set to Low. Make
sure you have a spare lamp handy if the usage hours on this menu
are close to the life span of your lamp.
Solving Projector Operation Problems
The power doesn’t turn on.
■ If the projector doesn’t turn on when you press the PPower
button, make sure the power cable is connected to the projector
and plugged into a working electrical outlet.
■ The power cable may be defective. Disconnect the cable from the
outlet and contact Epson as described on page 87.
■ Check to see if the A/V Mute slide is closed.
■ Check the status lights (see page 77).
The buttons on the projector don’t work.
If the control panels buttons have been locked, try using the remote
control instead. See page 62 for information about locking the control
panel.
note
The information displayed
depends on the input signal
currently selected.
To Next Page
Loading...
Need help?
General