62 Fine-Tuning the Projector
Choosing When to Display the Image
After your image is saved, it is automatically set as the startup screen.
You can also set it to display as the screen you see when there’s no
signal or when you press the
A/V Mute button (see page 30).
1. Press the
Menu button, highlight the Extended menu, and press
Enter.
2. Select
Display and press Enter.
3. Highlight
Display Background (for when there is no signal) or
A/V Mute, and press Enter.
4. Select
Logo and press Enter.
5. When you’re finished, press Esc to exit.
Disabling the Projector’s Buttons
You can lock all the projector’s control panel buttons, or all buttons
except the P
Power button. The projector can still be operated using
the remote control.
1. Press the
Menu button, highlight the Settings menu, and press
Enter.
2. Select
Control Panel Lock and press the Enter button.
3. Select
Full Lock (to lock all projector buttons) or Partial Lock (to
lock all buttons except the P
Power button) and press Enter.
4. Select
Yes and press Enter to confirm the setting.
5. Press the
Menu button to exit.
note
You can also use this menu
to turn off the startup screen,
disable message display, or
change the background
color.
note
To unlock the projector,
press the Enter button on the
projector’s control panel for
7 seconds.
To Next Page
Loading...
Need help?
General