• Never try to remove the lamp immediately after use because it will be extremely hot. Before removing
the lamp, turn off the power and wait at least an hour to allow the lamp to cool completely.
• Do not disassemble the lamp or subject it to impacts.
• Do not place the source of an open flame, such as a lit candle, on or near the projector.
• Do not block the lens during projection using a book or any object other than the lens cover. This could
damage the projector or cause a fire.
• Do not modify the power cord. Do not place heavy objects on top of the power cord or bend, twist, or
pull it excessively. Keep the power cord away from hot electrical appliances.
• If the lamp breaks, ventilate the room to prevent gases contained in the lamp from being inhaled or
coming in contact with your eyes or mouth. If you do inhale gases or gases come in contact with your
eyes or mouth, seek medical advice immediately.
• If the projector is mounted overhead and the lamp breaks, be careful to prevent pieces of glass from
falling into your eyes or mouth when you open the lamp cover. If pieces of glass do get into your eyes
or mouth, seek medical advise immediately.
• Always lower the volume before turning off the projector. Turning on the projector with the volume too
high can damage your ears.
Note: The lamp(s) in this product contain mercury. Please consult your state and local regulations
regarding disposal or recycling. Do not put in the trash.
WARNING: The cords included with this product contain chemicals, including lead, known to the State of
California to cause birth defects or other reproductive harm. Wash hands after handling. (This notice is
provided in accordance with Proposition 65 in Cal. Health & Safety Code § 25249.5 and following.)
Wireless LAN Module Safety Instructions
Restriction of Use
Parent topic: Notices
Wireless LAN Module Safety Instructions
Follow these safety instructions when setting up and using the wireless LAN module:
• Do not use the device near any medical equipment or cardiac pacemakers. Electromagnetic
interference from the device may cause such equipment to malfunction and cause an accident.
• Use the device only with an Epson projector. If it is installed in another device, such as a computer, it
may cause damage or malfunctions in the other device.
• Do not disassemble or remodel the device; internal components may cause burns.
168
To Next Page
Loading...
Need help?
General
Weight and Dimensions
