Publishing Discs 20
& See “Batch Mode” on page 41.
Drive settings
Drive to be used
Select Drive to Use from the following.
Use Both
Use both Drive 1 and 2 to write data. Job will be efficiently processed by using 2 drives. If
trouble occurrs on either drive and it cannot write data, other drive will be used
automatically.
Use Drive 1 Only
Use only Drive 1.
Use Drive 2 Only
Use only Drive 2.
Number of write retries
Select 0 to 9 for the Number of write retries.
The Number of write retries is a setting to retry writing if a write error occurs.
Setting the Number of write retries will enable the job to continue without pausing if a write
error occurrs.
Printer settings
Printer name
Select Printer Name.
Note:
When changing the printer name, do not use Unicode characters. The device will not be recognized
correctly.
To Next Page
Loading...
