Epson RC+ 7.0 - Page 21

2. Description
Part Feeding 7.0 IF-240 Rev.5 13
The following connection schematic shows the methods to connect to the IF-240 depending
if your application requires an external relay to ensure that the backlight is safely switched
off or not. In any case, both “Power” and “S-Power” have to be supplied for using the
backlight.
Figure 2-8:
Figure 2-9:
Power connection without
safety relay
Power connection with
safety relay
Both Power and S-Power can be connected to a single power
supply or to two different power supplies.

NOTE