Epson RC+ 7.0 - Page 41

4. Maintenance and component replacement
Part Feeding 7.0 IF-240 Rev.5 33
Step 4
Parameters in memory can now be modified by RC+.
For more details, refer to Software 2.1 System Settings.
Step 5
When parameters are defined as desired, replace selector 2 in position (C).
1234
(C)
Step 6
Disconnect and reconnect the power cable (or switch off and switch on the power of the
IF-240).
The IF-240 will use the parameters defined by the new startup.
Step 7
Replace the cover and screw the 3 screws (A) Use a torx key size 10 (0.9N·m)