F
Insert the new wiper unit.
Place on the attachment point and press down
until you hear a click.
G
Unpack the new anti-drying cap, and then
remove the cover.
H
Press the lever towards you, and then lift the
anti-drying cap to remove it.
I
Attach the cover removed in step 7 to the old
anti-drying cap, and then put it into the bag of the
new anti-drying cap.
J
Press the lever forwards, and then place the holes
in the anti-drying cap over the two poles on the
printer.
K
Close the printer cover, and then press the Z
button.
L
Press the u/d buttons to highlight Yes, and then
press the Z button.
Press the Z button to move the print head to the
flushing pad replacement position.
M
Open the printer cover.
N
Lift up the tab on the flushing pad, and remove
it.
c
Important:
Do this carefully as ink could spray out if it is
raised with too much force.
SC-F2100 Series Operator's Guide
Maintenance
48
To Next Page
Loading...
Need help?
General