Epson SC-F3000 Series

C
Gently press on the section from which the back
has been peeled off the grip pad to stick the grip
pad onto the platen.
D
Peel off all of the other sections on the back of the
grip pad as shown in the illustration.
E
Stick it from the end that is already stuck, as
shown in the illustration.
Removing the Sheet
c
Important:
❏ Do not apply hot air such as a drier to soften the
glue. Failure to observe this precaution could
result in deformed parts.
❏ Do not use organic solvents such as alcohol.
Failure to observe this precaution could result
in discoloration, warping, or damage to parts.
A
Place the platen on a flat surface and press on the
front side.
B
Peel off the grip pad from back to front.
SC-F3000 Series User's Guide
Basic Printing
55