Replacing and
Adjusting the Print
Head
Preparation
Use the following to do replacement work.
Replacement Print Head
Do not remove it from the protective case until just
before replacement.
Gloves (provided with replacement Print Head),
protective glasses and mask (commercially
available)
Prevent ink from coming into contact with your skin or
from entering your eyes or mouth.
Media for adjustments
Prepare the media specified during User Self Repair
training.
Premium Glossy Photo Paper (250) (product number:
S041638)
Notes on Handling
Print Heads are precision components.
When handling them, follow the procedures and
precautions in this manual.
Notes on Storage
❏ Do not open the outer carton or the protective case
before doing replacement work. There is a risk of
lint or dust getting on the nozzle surfaces and ink
supply ports.
❏ Store them in the following environment, away
from direct sunlight.
-20˚C to 60˚C (-4 to 140˚F) (without condensation)
❏ Do not store in damp location.
❏ Store correctly in upright orientation.
❏ Do not stack more than 3 boxes.
Notes on Opening
❏ Confirm the box is upright before opening it.
❏ Use the outer carton, plastic bag, and protective
case to pack the used Print Head to send it to your
dealer or Epson Support. Open them carefully
without tearing anything.
❏ Do not open the protective case until you are ready
to replace the Print Head. There is a risk of lint or
dust getting on the nozzle surfaces and ink supply
ports.
Correctly Holding the Print Head
When replacing the Print Head or removing it from its
protective case, use both hands and hold it at the
positions shown in the photos.
SC-R5000 Series/SC-R5000L Series User Self Repair Guide
Replacing and Adjusting the Print Head
11
To Next Page
Loading...
