How to Start in User
Self Repair Mode
A
Check that the printer's power is off.
B
While holding down the [ ] and [ ]
buttons on the control panel, press and hold the
P button for approximately 10 seconds.
C
When the following screen is displayed, release
all of the buttons and press OK.
Starting is successful if User Self Repair Mode
appears in the upper left of the screen, as in the
illustration.
If it does not appear, turn off the power and redo
the procedure from step 2.
SC-R5000 Series/SC-R5000L Series User Self Repair Guide
How to Start in User Self Repair Mode
9
To Next Page
Loading...
